■Flow rate:Q=9~460 (m³/h)
■Total head:H=10~65 (m)
■Speed:n=1450rpm
■S.g.:γ ≤1.5
■Temperature:T=0~80℃
■Pump diameter:50~200mm
■Conforms to JB/T8096-1998 standard.
■Double bracket structure design increases the reliability and stability.
■Optimized hydraulic models with better ability to fit the applications.
■Several standard installation depths,a suction pipe can be added to the pump inlet if the installation depth is above 1.5 m.
■Low pump speed and linear speed design to reduce the abrasion of pump.
■Various anti-abrasion materials for different applications.
■Single casing structure,casing is connected to the connecting pipe,and connecting pipe is connected to the bearing housing,and bearing housing is connected to the baseplate.
■Cylinder type bearing housing with rolling bearings.
■Restrictor seal without external flushing water.
■Transmission: Direct coupled,variable frequency drive.
Structure drawing is as below
1.suction pipe 2.pump body 3.impeller 4.guard 5.take over 6.shaft 7.base 8.bearing seat 9.bearing box 10.motor seat 11.electric connector 12.pump coupling 13.bearing 14.bearing 15.outlet pipe 16.bearing
■Material of flow passage components based on pumped medium: Cr26 wear-resistant material, or Cr30, CD4MCu wear-resistant and anti-corrosion material, and other general wear-resistant material, such as gray cast iron 200, Z-1#, C-15, ZG40Mn2.
■Material of outlet pipe, base etc. parts: Q235-A.
■Sewage conveying of power plant,mining,cement,steel,non-ferrous metal.
■Fluid conveying of aluminum oxide producing process.
■Slurry conveying of sedimentation basin of other industries.