Since 1967-Chemical pump factory-Sichuan Zigong Industrial Pump Co.,Ltd--

Click the picture to see more

资料下载

Online consulting BFQ

Brief introduction

Aiming at the characteristics of flue gas desulfurization project of thermal power plant, a new generation of desulfurization pump products carefully developed to meet the needs of pumps for limestone (lime)/gypsum wet flue gas desulfurization process of coal-fired power plants. The hydraulic model is optimized by CFD, and the slurry pump design is applied to the flow path design. The over-current components adopt self-developed wear-resistant and corrosion-resistant alloy cast iron materials, which embodies high efficiency, low energy consumption, low operating cost and high reliability. Features. At present, the products with the largest diameter up to Φ900mm have been developed. The series products are widely used in flue gas desulfurization and denitrification projects in electric power and environmental protection industries.

■Flow: Q=700～14000 (m3/h)

■ Lift: H=15~63 (m)

■Speed: n=420~980rpm

■ Specific gravity: γ ≤ 1.5

■Temperature: T=0～120°C

■Caliber: 300~900mm

■Designed for the flue gas desulfurization project of thermal power plants to meet the flue gas desulfurization process of 1000MW and below

■Hydraulic model is optimized by CFD and has excellent anti-cavitation performance

■Mechanical sealing device specially designed for flue gas desulfurization process, with unique reliability and applicability

■The pump rotor component can adjust the position of the impeller in the pump cavity through the rear bearing box, providing a convenient means to restore the pump performance after mild wear.

■Axial adjustment structure design, can maintain the gap between the impeller and the front cover by adjustment, so as to operate with high efficiency

■The wear-resistant and corrosion-resistant two-phase stainless white iron specially developed for the FGD process, which has the advantages of duplex stainless steel and alloy white-mouth wear-resistant cast iron.

■The pump is made of all metal pump structure, without rubber or other polymer materials.

■The pump body is made of 2605N or 2205 duplex stainless steel. It has good resistance to chloride and sulfate ions and is the material of choice for metal materials for desulfurization pumps.

■The pump is front and rear open structure, no need to disassemble the pump inlet and outlet pipeline when disassembling the impeller, mechanical seal and other components

■Mechanical seal is single-end cartridge type seal, user can choose internal flush type and external flush type

■The bearing components adopt suspension and rear pull structure, and the pump drive adopts direct transmission or variable speed transmission.

4.2.jpg

1.bearing cover 2.filler cover 3.shaft 4.filler 5.vice-impeller 6.pump body 7.impeller nut 8.front pump cover 9.impeller 10.back pump body 11.shaft sleeve 12.bearing box 13.bracket 14.bearing box 15.bearing 16.bearing gland 17.shaft

■Material of flow passage components based on pumped medium: 2605N or 2205 duplex stainless steel, and Cr30 wear-resistant and anti-corrosion material especially for FGD device absorption tower.

■Material of suspension, bearing box etc. parts: gray cast iron 200.

4.1.jpg

■Mainly used as circulation pump of gypsum slurry of absorbing tower of FGD process.

■Slurry pump of ammonium phosphate

■Other applications of big flow rate and low head.

欢迎使用ueditor!

Products&Service

ZTD desulfurization slurry circulation pump

Brief introduction