■Advanced hydraulic models with high efficiency and wide performance range.

■Smooth operation and low noise.

■Both packing seal and mechanical seal are available.

■Completely sealed shaft which is non-contact with fluid.

■The pump material can be changed to pump corrosive fluids. D(F) stands for a pump which is suitable for corrosive fluids,but its performance and is totally the same to D series.

■The pump set mainly consists of bearing housing,inlet and out section,middle section,guide vanes.

■The pump inlet is horizontal and outlet is vertical;The balance hose on the inlet is connected back to the water inlet side.

■Between bearings structure.The rotary part consists of shaft,impellers and a balance disk.

■The gaps between pump inlet section,middle section and outlet section are smeared by molybdenum disulfide compound calcium-based lubricating grease as the sealings. The gaps of rotary part and static part are sealed seal rings,guide vane sleeve and packing.

■Standard shaft sealing is packing,can be customized as mechanical seal.

Structure drawing is as below

1. Inlet section 2. Guide vane 3. Middle section 4. Outlet section 5. First-stage impeller 6. Impeller 7. Balance disk 8. Balance plate 9. End cover 10. Packing 11. Balance sleeve 12. Packing gland 13. O ring 14. Bearing 15. First-stage seal ring 16. Seal ring 17. Guide vane sleeve 18. Shaft 19. Shaft sleeve

■HT200

■ZGCr28

■ZG1Cr18Ni9

■ZG1Cr18Ni9Ti

■ZG0Cr18Ni12Mo2Ti

■ZG1Cr18Ni12Mo2Ti

■Widely used in mining,factories and city water supply and drainage.

■Suitable to pump clean water and fluids have close physical and chemical characters of water,or fluids like hot water,oils,corrosive material and particles.